How To Clean Afe Magnum Force Air Filter

Air Filter Cleaner (Dry)

Air Filter Cleaner (Oiled)

Formulated for Dry out & Oiled aFe Air Filters

Our cleaners take been particularly formulated for use with aFe POWER filter media – one for oiled filters and one for dry. These powerful cleaners gently lift and loosen dirt, so it can be easily rinsed abroad, restoring your filter to like-new condition. The cleaning process can be repeated whenever necessary.

Air Filter Cleaning Kits

aFe filter oil is highly refined and helps capture even the smallest debris. Examine your air filter every iii-9k miles. For optimal engine operation, we recommend re-oiling every 20-30k miles.

Pro DRY Southward Cleaning Kit

This eco-friendly air filter cleaner is for the aFe POWER Pro Dry S operation air filter. Simply spray it on, wash it off, and your Pro Dry out Due south air filter is proficient to get. No oil is needed.

Pro 5R / 10R Cleaning Kit

The aFe filter restore kit comes with your option of a squeeze bottle or aerosol can of aFe blue filter oil and a spray bottle of aFe filter cleaner. This cleaning kit is also bachelor in a 32oz squeeze bottle kit.

Pro-Guard seven Cleaning Kit

The aFe filter restore kit comes with your choice of a squeeze bottle or aerosol can of aFe aureate filter oil and a spray bottle of aFe filter cleaner. This cleaning kit is too available in a 32oz squeeze canteen kit.

How to Make clean Your aFe POWER Air Filter to Maintain Performance

Before you begin, gently tap the filter element to remove embedded dirt. Gently brush the remaining backlog dirt from the element with a soft castor.

1. APPLY CLEANER
Using aFe "Restore Kit" power cleaner, spray the chemical element thoroughly soaking the cotton wool media. Permit it soak for approximately 10 minutes.

2. RINSING WITH TAP WATER
Using low pressure from a tap or a hose, run water from the clean side to the dirty side. Continue running the h2o through the element until the water comes through articulate. Do NOT Apply HIGH Pressure or a nozzle that sprays a sharp stream. A sharp spray of water can separate the filter media thus ruining the filter

3. Allow FILTER Stand up UNTIL Dry
Information technology is best to let the filter dry out naturally. Information technology is OK to lay the filter in front of a fan to speed drying. Do not do the following: *Practice NOT use high estrus such as a hair dryer. aFe filters are cotton and can shrink nether high heat. *DO NOT use compressed air every bit it can separate the media making an unseen hole for dirt to pass through. *DO Non use open flame.

4. APPLY CORRECT AFE OIL TO FILTER (Pro 5R, Pro 10R, or Pro-Guard vii)
Apply aFe special formula air filter oil to re-oil the filter media every bit follows:

4A. Clasp bottle oiling (shown) - Apply a modest amount of oil to the peak or bottom of each pleat stopping about 1/ii" to 3/4" from the edge of the filter. Within 20 minutes the oil should spread to cover the entire filter media surface area leaving no media uncovered. Touch up any spots that are still visibly white with a small corporeality of oil.

4B. Droplets tin can oiling - Hold the can approximately 5 to 8 inches from the filter, spray a light single coat of aFe filter oil covering each section at a slow step.

Note: Only apply oil to one side of the filter. The oil volition wick through the media.

* NEVER use an aFe filter without oil. The oil is required to capture the effectively clay particles.

*NEVER use motor oil, transmission fluid, diesel fuel, WD 40, etc. in place of aFe oil.

Source: https://afepower.com/air-filter-cleaning-kit

Posted by: smithcoulp1969.blogspot.com

Share this post